How to deal with the heavy steering wheel of dynamic compaction machine? What are the reasons for heavy steering wheel of road roller? How to eliminate it? What are the main reasons for heavy steering wheel and its elimination methods? Dynamic compaction machine rental Xiaobian to tell you:

转向液压油温度太低，应当等小型压路机的液压油温度升高后再开始工作.

If the temperature of steering hydraulic oil is too low, it should wait until the hydraulic oil temperature of small roller rises

转向泵供油不足。应检查油泵是否磨损或损坏，严重时更换油泵总成.转向油路中进入空气，造成转向油缸时动时不动。应排除系统中的空气，并检查转向泵吸油管是否松动漏气。

The steering pump is not supplying enough oil. Check whether the oil pump is worn or damaged. If it is serious, replace the oil pump assembly. Air enters into the steering oil circuit, causing the steering cylinder to move or not. Remove the air from the system and check the steering pump suction pipe for looseness and air leakage.

强夯机租赁

Lease of dynamic compaction machine

强夯机的转向系统压力低.应按规定调整滋流阀的压力，或清洗溢流阀，更换弹簧或密封圈。

The pressure of the steering system of the dynamic compaction machine is low. The pressure of the overflow valve should be adjusted according to the regulations, or the overflow valve should be cleaned, and the spring or sealing ring should be replaced.

大黄蜂提示您由于采用全液压转向器的压路机转向压力过低，应根据其不同型号予以检修。

Bumblebee reminds you that since the steering pressure of the roller with full hydraulic steering gear is too low, it should be overhauled according to its different models.

对于全液压转向器，可能是转向器计量马达部分螺栓拧得过紧，应将螺栓放松。也有可能是转向器内钢球单向阀失效，应清洗出脏物，使钢球与阀体密封带接触良好。

For the full hydraulic steering gear, the bolts of the metering motor of the steering gear may be too tight, so the bolts should be loosened. It is also possible that the steel ball check valve in the steering gear fails, so the dirt should be cleaned out to make the steel ball contact with the valve body sealing belt well.